Real-time meter reader

How to read my electric meter: dials, digital and smart meters

To read your electric meter, find the kWh register: on a digital or smart meter it is the number the display cycles to with "kWh" beside it; on an old dial meter it is the row of four or five clock dials, read from left to right. Write it down, read it again later, and the difference is the electricity you used in between.

Which meter do you have?

MeterWhat you seeWhat to read
Dial (analog)Four or five small clock faces, some turning clockwise and some counter-clockwiseEach dial's digit, left to right
DigitalAn LCD with one number, sometimes cycling through a test patternThe number labelled kWh (ignore kW, V and the all-8s test screen)
Smart (AMR/AMI)An LCD plus a radio module; often an "ERT" label, a radio or antenna icon, or a utility stickerThe kWh register, or let the meter tell you over the air (below)

Reading a dial meter, step by step

  1. Read the dials from left to right. Neighbouring dials turn in opposite directions, so look at which way the numbers run on each one.
  2. When the pointer is between two numbers, write the lower one. Between 9 and 0 counts as 9.
  3. When a pointer sits right on a number, check the dial to its right: if that one has not passed zero yet, use the number below.
  4. Put the digits together. Five dials reading 4, 0, 8, 2, 7 mean 40,827 kWh. Some meters print a multiplier ("x10"): multiply by it.

Reading a digital or smart meter

Wait for the display to cycle. Most show a segment test (all 8s), then the cumulative kWh, then other values such as instantaneous demand in kW or a time-of-use register. The one you want for a bill is the total kWh; time-of-use meters may also show separate on-peak and off-peak registers.

Tip: take a photo of the display each time. The photo's timestamp gives you the date and time of the reading for free.

From readings to usage

Usage is simply the later reading minus the earlier one. Read the meter in the morning and again the next morning and you have one day's kWh; multiply by your rate per kWh from your bill to get the cost. Read it before and after running the dryer and you know what one load costs.

Doing that by hand gets old fast, which is where a smart meter reader app comes in.

Let the meter read itself

Most smart meters in the US and Canada broadcast their register over the radio every 30 to 60 seconds so the utility can read them from a passing truck. With a $30 RTL-SDR USB dongle, Utilify picks up that broadcast for your own meter, so you get a reading every half-minute without walking outside: an hourly chart, the cost at your rate, and gas and water meters too. See how to read your smart meter with an RTL-SDR for the hardware, and smart meter frequencies and protocols to check whether yours broadcasts.

Utilify is not your utility's app: it cannot submit a reading for your bill. If your utility asks you for a meter reading, use their own website or app.

Read your meters with Utilify

Plug in an RTL-SDR dongle and start reading your own meters in seconds. No utility account, no cloud.

More guides: Home & hobby · all Adelyons guides